Supplies
- Vinyl tegels
- Afstandhouders (3 mm)
- Voegmiddel voor vinyl
- Spuitzak of raapspaan
- Spons
Step 1
Start by loosening the back of the tile. Attention! Do not remove the entire protective layer immediately. You only do this once the entire tile is in place.
Step 2
Put the tile on its new spot.
Step 3
As soon as the last edge is in place, you can remove the entire protective layer.
Step 4
Use spacers of about 3 mm, between each new vinyl tile you lay.
Step 5
In order to deliver the floor neatly, we are also going to grout it.
You can apply the joints in two ways. With a turnip trowel or with a piping bag. That’s up to you.
Step 6
Apply the grout to the ground with a turnip rake or piping bag.
Step 7
Ga dan met een spons over de vloer. Veeg de waas rondom de tegels weg en maak de tegels zelf schoon. Let op! Gebruik een droge spons als je over de voegen heen gaat. Voor het schoonmaken van de tegels kun je wel een vochtige spons gebruiken.
Stap 8
After 24 hours the grouts are dry and you can start using the vinyl floor. Enjoy!